Pro-Line Engine Flush

DESCRIPTION Pro-Line Engine Flush is a development product based on highly effective state-of-the-art additive technology. These highly effective detergent and dispersant additives in association with the carrier fluid have been tested in the laboratory and in practical field trials for their ability to dissolve sludge and lacquer formers.
All types of oil-soluble and oil-insoluble residues are brought into suspension and removed during the next oil change. An engine which has been cleaned of deposits and contamination and which is then filled with fresh oil not contaminated
with old impurities can develop its full performance characteristics. -

PROPERTIES

- gentle and rapid cleaning
- neutral to seals and other materials installed in the engine
- compatible with catalytic converters
- highly economical
- no additional environmental pollution
- simple to use

TECHNICAL DATA

Colour : brown
Basis : additive/carrier liquid
Flash point : 60 °C
Pour Point: -45 °C
Density at 20 °C : 0.82 g/cm3

APPLICATION Cleaning and flushing out the oil systems of petrol and diesel engines.

INSTRUCTIONS One 500 ml can is sufficient for up to 5 litres of oil. Add Pro-Line Engine Flush to the engine oil at running temperature before changing the oil. After adding the product, allow the engine to idle for approx. 10 to 15 minutes depending on the degree of contamination. Then change the oil and the filter.Pro-Line Engine Flush is compatible with all commercially available engine oils
Note: Not suitable for use on motorbikes with wet clutches.

AVAILABLE
PACK SIZES Pro-Line Engine Flush

500 ml Part. no. 2427
1 l Part. no. 2425
5 l Part. no. 2428